Shark UV610 User Manual download pdf (Page 3)

HOW TO OPERATE YOUR CORDLESS SWEEPER

CLEANING THE DUST CONTAINER

1. Before using, please ensure that the cordless sweeper has been initially

charged for 16-20 hours

Your cordless sweeper will only operate properly when the batteries are fully

charged. When fully charged your sweeper will operate for 35-45 minutes -

dependent upon the type of use (example - carpets or bare floors).

2. Push the On/Off switch to operate the unit. To turn off , press switch again.(Fig.4)

NOTE: Do not operate the sweeper without the dust container in place.

To achieve the best performance, empty the dust container after each use.

1. Pull the dust container straight out from the side. (Fig. 6)

Fig. 7

2. Empty dust container contents. (Fig. 7) If desired- you may rinse with water to

clean the dust container - but dry thoroughly before replacing on the sweeper.

Fig. 8

3. Replace dust container on cordless sweeper.

4. Periodically remove the transparent brush cover on the front of the cordless

sweeper and remove any build up of lint, hair or fiber on the rotating brush. To

remove the cover - grip the cover from the bottom, pull out and upward until

the cover unlocks from the side slots and tabs located on the top of the

sweeper. (Fig. 8)

Fig. 8

CAUTION: Do not accidentally turn unit on while cleaning. Do not

clean while unit is charging.

Fig. 6

Fig. 7

“On/Off” switch

Fig. 4

CAUTION: Any electronic or electrical appliance

should not be stored in or exposed to

areas of high heat or humidity. Do not store

your cordless sweeper close to stoves,

radiators, furnaces or in a bathroom or bathing

area.

3. To release the handle to a comfortable position, apply pressure to the top of

the sweeper head with your foot while pulling back on the handle.(Fig. 5)

Fig. 5

1 2 3 4 5 6

No comments

Shark UV610 User Manual Page 3