Shark UV610 User Manual download pdf (Page 4)

CHARGING THE CORDLESS SWEEPER Changing the Rotating Brush & Gear Box

WARNING: Use caution when changing the rotating brush and gear box

so that the unit does not turn ON when pressing down on the

sweeper power head.

1. Connect the charger plug to the charging jack or hole on the back of the

sweeper. Plug the the charging adapter into the wall outlet. (120V~,60Hz.) Use only

TechWorld Charger AD-0920-UL, rated output DC 9V,200mA. (Fig. 9)

2. This cordless sweeper is powered by Ni-Cd batteries. Before first use,

they must be charged for a minimum of 16 hours.

3. Once the batteries are fully charged, the cordless sweeper will run for

approximately 35 to 45 minutes before recharging is required.

4. When recharging the unit, the “On/Off” switch must be in the “OFF” position.

5. To recharge, repeat step #1 above. Charging times will vary depending upon

the amount of usage between charging cycles.

6. The charging light indicator on the top of the sweeper will illuminate

to indicate that the sweeper is properly charging.

1. Remove the extension tube handle from the sweeper power head.

2. Turn sweeper power head upside down being careful Not to accidentally turn the

unit ON.

3. Remove the transparent brush cover. (Fig. 10) (Refer to page 5 for detailed

instructions.)

4. Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 11 &

Fig. 12)

5. Lift the brush bar end cap up from the slot. (Fig. 13)

6. Pull the brush bar out from the bushing and slip off the belt to remove the

brush bar. (Fig. 14)

7. Insert the new brush bar by first inserting the brush bar into the bushing on the

end opposite the driver belt. (Fig. 14)

8. Slip the belt over the brush bar cap.

9. Insert the brush bar into the slot. (Fig. 13)

10.Insert the gear box tabs into the tab slots and push down until it clicks into place.

Gear box

tabs

Locking

tab

Lift

Gear box

Fig. 11

Fig. 12

Fig. 9

NOTE: Peak performance may only be realized after the unit

has been charged and discharged two (2) or three (3)

times.

IMPORTANT: To maintain peak performance of your cordless

sweeper, it is recommended that the unit be fully

discharged, then completely re-charged at least

once a month.

Fig. 10

CAUTION

• Use only with the battery pack supplied with the unit.

• Do not attempt to remove the battery pack from the unit to charge it.

• Never attempt to throw the battery pack or unit into a fire or incinerate

it.

• Do not attempt to remove or damage the battery casing.

• Battery must be recycled or disposed of properly at the end of it's

service life.

Fig. 13 Fig. 14

1 2 3 4 5 6

Comments to this Manuals

No comments

Shark UV610 User Manual Page 4

Comments to this Manuals

Related products and manuals for Vacuums Shark UV610