Customizing Wireshark
181
2. Do not decode: Do not decode packets the selected way.
3. Link/Network/Transport: Specify the network layer at which “Decode As” should take place.
Which of these pages are available depends on the content of the selected packet when this dialog
box is opened.
4. Show Current: Open a dialog box showing the current list of user specified decodes.
5. OK: Apply the currently selected decode and close the dialog box.
6. Apply: Apply the currently selected decode and keep the dialog box open.
7. Cancel: Cancel the changes and close the dialog box.
10.4.3. Show User Specified Decodes
This dialog box shows the currently active user specified decodes. These entries can be saved into
current profile for later session.
Figure 10.6. The “Decode As: Show” dialog box
1. OK: Close this dialog box.
2. Save: Save the entries in the table into current profile.
3. Clear: Removes all user specified decodes without updating the profile.
10.5. Preferences
There are a number of preferences you can set. Simply select the Edit → Preferences… (Wireshark
→ Preferences… on Mac OS X) and Wireshark will pop up the Preferences dialog box as shown in
Comments to this Manuals