Battery Removal & Disposal
NOTE: If uncertain as to how to remove your battery pack, we suggest you take
your sweeper to a reputable small appliance service technician to have this
service performed.
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them
properly. When the batteries are no longer good for use, they must be removed from
the sweeper for disposal. Do not remove the batteries for any reason other than
disposal of them. The batteries must be recycled or disposed of in accordance with
local regulations. Please consult your Yellow Pages or local recycling center for more
information.
WARNING: You must never use ordinary batteries for replacement as
these may leak and cause damage. Use only battery pack
X1725QN provided for replacement.
7
OPERATING INSTRUCTIONS
To Maximize the Life of Your NiCd Batteries
1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce the
product’s battery life significantly.
2. Do not store the unit with the charging adaptor attached and plugged in.
3. Only recharge when the batteries are fully discharged (or as close to fully discharged
as possible).
4. Do not store in areas of high temperature or humidity.
5. After three (3) months of storage, the product should be fully discharged and then
recharged to maximize battery power.
6. Use only the charger supplied with the product. If other chargers are used, the
batteries can fail causing damage to the battery, product or personal property. NiCd
batteries have a long useful life but at some time they will need to be replaced. To
purchase replacement batteries call Customer service at 1 (800) 798-7398.
NOTE:
1. The on/off switch must be in the “Off” position in order to charge the unit. If
the charging indicator does not light, depress the on/off switch once.
2. If the product has never been used or has been stored for an extended period
of time without use – it will take several complete charge and discharge cycles
to realize the full operational time of your product.
8
OPERATING INSTRUCTIONS
Removal of Battery Pack
1. Turn unit over so that the base is facing upwards. Be careful not to turn the unit
“On”. (Fig. 10)
2. Push in locking tab and lift off battery compartment cover. (Fig. 11)
3. Lift out battery pack, disconnect battery connector and set the battery aside.
4. Connect battery connector and insert the new battery pack into unit. Replace the
battery compartment cover making certain that the locking tab snaps in place.
Fig. 10 Fig. 11
CAUTION: This appliance contains Ni-Cd batteries. The batteries must
be recycled or disposed of in accordance with local
regulations. Please consult your Yellow Pages or local
recycling center for more information.
Locking Tab
(14 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals