Shark V1935Q User's Guide download pdf (Page 3)

Assembling your Cordless Sweeper

1. Insert the lower handle onto the power head. Fasten it with the captive nut and bolt

provided. (Fig. 1) The captive nut and bolt are found secured to the end where the

lower handle will be inserted.

Before you start:

Your Cordless Sweeper will require very little assembly. You should remove it from the

carton and familiarize yourself with all the components listed per the exploded view

drawing (pg.2). This will help you in the assembly and operation of your cordless

sweeper.

NOTE: The charging adapter may be shipped inside the dust cup.

Fig. 2

CAUTION: ALWAYS USE ADAPTOR SUPPLIED (ONLY) WITH

SWEEPER.

2. Assemble the handle by inserting the lower handle extension tube

into the lower handle. Push until you hear it snap into place. Next,

push the plastic folding pivot onto the lower handle extension

tube until you hear it snap into place. Finally, insert the upper

handle into the forward folding until you hear it snap into

place. (Fig. 2)

3. Place the handle into the upward storage position.

4. Plug the charging adapter into the sweeper power

head charging jack. Plug the charging adapter cord

into a standard electrical outlet (120V., 60Hz.) The

green charging indicator light should illuminate.

If the charging indicator does not illuminate,

depress the on/off switch once to reset the unit.

Fig. 1

Captive

Nut

Lower Handle

Bolt

OPERATING INSTRUCTIONS

How to Operate Your Cordless Sweeper

CAUTION: Any electronic or electrical appliance should not be stored

in or exposed to areas of high heat or humidity. Do not

store your cordless sweeper close to stoves, radiators,

furnaces or in a bathroom or bathing area.

NOTE: Before using, please ensure that the cordless sweeper has been initially

charged for 20 hours.

Your cordless sweeper will only operate properly when the batteries are fully charged.

Your sweeper will operate for varying lengths of time on a full charge. This will depend

upon the type of surface being cleaned. (Longer operating time on bare floors vs

carpets.)

1. Push the on/off switch to operate the unit. To turn “Off”, press switch again. (Fig. 3)

"On/Off“

switch

Fig. 3

2. To fold the handle, press on the handle release button while bending the handle

forward. The folding pivot will click into the bent position. (Fig. 4)

3. To straighten the handle, simply lift the upper handle. The folding pivot will click

into the straightened position. (Fig. 5)

Fig. 5

Fig. 4

Handle

Release

Button

OPERATING INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Shark V1935Q User's Guide Page 3

Comments to this Manuals

Related products and manuals for Environment thermometers Shark V1935Q