Shark SSD-503061E Operator's Manual download pdf (Page 11)

SSD DIESEL SERIES

OPERATOR’S MANUAL

SHARK SSD DIESEL • REV. 1/03

If the desired position cannot be obtained using only the

air shutter, lock the air shutter in as close a position as

can be obtained, then repeat the above procedure on

the air band setting.

Coil Removal:

Removal of coil because of freeze breakage, or to clean

soot from it can be done quickly and easily.

1. Disconnect hose from pump to inlet side of the coil.

2. Carefully disconnect the thermostat sensor making

sure you do not crimp the capillary tube.

3. Remove burner assembly from combustion chamber.

4. Remove the 3-3/8" bolts from each side of coil and

tank assembly (these bolts are used to fasten tank

to chassis).

5. Remove fittings connected to the 1/2" pipe nipples

from inlet and discharge sides of coil.

6. Remove top tank wrap, bend back insulation tabs

and fold back blanket.

7. Remove bolts that hold down coil to bottom wrap.

8. Remove coil.

9. Replace or repair any insulation found to be torn or

broken.

10. Remove insulation retainer plates.

Coil Reinstallation:

Reinstall new or cleaned coil reversing Steps 9 through 1.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

No comments

Shark SSD-503061E Operator's Manual Page 11