Shark UV300 Specifications download pdf (Page 10)

TOLL FREE: 1-800-798-7398

Proper Care of Your Shark

Upright Vacuum

COMPONENT

MAINTENANCE SCHEDULE

Rinse and air dry every month under normal use.

Empty each time you vacuum.

Pre-MotorFoamFilter

Dust Cup

Rinse and air dry every month under normal use.

Pre-MotorFeltFilter

Clean once every 12 months under normal use.

Post-MotorFilter

DO NOT put the ﬁlters in the washing machine or dishwasher.

NOTE: The material in the ﬁlter will discolor over time. This is

NORMALandwillnotaffecttheperformanceoftheﬁlter.

CAUTION:

Unplug

the vacuum while

cleaning ﬁlters; failure

to do so might result

in electric shock.

CLEANING THE PRE-MOTOR

FILTERS

1 Remove the dust cup.

2 Pull the 2 ﬁlters out from the

top of the motor base.

(Fig. 19)

3 Rinse the ﬁlters thoroughly in

lukewarm water until the water

runs clear.

4 Squeeze out excess water and

let air-dry for at least 24 hours

before replacing. Do not use

a hair dryer or other heating

methods to dry.

5 Place the felt ﬁlter in ﬁrst, then

the foam ﬁlter.

6 Replace the dust cup.

Fig. 20

CLEANING THE POST-MOTOR

FILTER

1 Remove the ﬁlter cover from

the front of the vacuum by

pulling up on the tab and

pulling the cover away from the

vacuum. (Fig. 20)

2 Remove the ﬁlter from the

frame and wash the ﬁlter under

the tap using lukewarm water.

3 Allow the ﬁlter to air dry for 24

hours. Do not use a hair dryer

or other heating methods to

dry.

4 Once the ﬁlter is dry, replace it

back into the vacuum.

5 Replace the cover by inserting

the two tabs into the holes at

the top and and then swinging

the cover down until it clicks

into place.

NOTE: Filters may appear dirty

but frequent cleaning of these is

not necessary. See maintenance

schedule above.

Pre-Motor

Foam Filter

Felt Filter

Fig. 19

IMPORTANT: Loss of Suction may

occur if foam ﬁlters are not cleaned

every month. Rinse and allow to air dry

completely.

Foam ﬁlters may appear dirty after use -

this is normal.

UV300_26_IB_ENG_SPA_111005_1.indd 8 12-05-23 11:45 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Shark UV300 Specifications Page 10

Comments to this Manuals

Related products and manuals for Vacuum cleaners Shark UV300