Shark KD450W Specifications download pdf (Page 13)

www.shark sonicduo.com

IMPORTANT: Do not use on unsealed wood

or unglazed ceramic ﬂoors. Do not use on wood

or tile ﬂoors that are highly worn, unﬁnished

or have a wax or oil ﬁnish. Surfaces that have

been treated with wax or some no wax ﬂoors

may be damaged by the cleaning and polishing

solutions therefore it is always recommended to

test an isolated area of the surface to be cleaned

or polished before proceeding. You should check

the use and care instructions from the ﬂoor

manufacturer before cleaning or polishing.

IMPORTANT: Do not use more than one brand

of ﬂoor polish to polish one room. Use only

Shark

Wood & Hard Floor Polish.

Frequently Asked Questions

Q. Polishing has left my ﬂoors streaky or spotty.

A. You should go over the streaky or spotty

area with more polish. Always leave the area

looking very wet, never dry.

Q. There is a footprint, smudge or uneven spot after

or during polishing.

A. You should add more polish to any problem

areas during polishing. Always leave the area

looking very wet, never dry.

Q. I accidentally ran the Shark

Wood & Hard Floor

Polish through the Sonic Duo

™

and now it is

not working properly.

A. Shark

Wood & Hard Floor Polish should

always be squirted directly onto the ﬂoor . If it

was run through the unit, you need to ﬂush it

out immediately. Fill the Reusable Bottle with

warm water and spray it through the system

to ﬂush it. Then turn and remove the tip of

the nozzle to clean it. (Fig. 26) Call Customer

Service at 1-800-798-7398 for additional

assistance if necessary.

Using the ScrubDuster

™

(may not be included):

Use the ScrubDuster

™

with the Scrubbing Pad to

remove tough stains and dried on dirt or the Dusting

Pad to dust around and reach inside the narrowest

crevices for a true Total Clean in every nook and

cranny.

1 Attach one side of the Scrubbing Pad or the

Dusting Pad to the Velcro

strip on the front side

of the ScrubDuster

™

and then bring it up and

attach it to the Velcro

strip on the back. Make

sure that the pad is attached tightly.

(Fig. 27, Fig. 28) Extend the wand for easier

reach.

ﬁg. 26

ﬁg. 28

ﬁg. 27

(may not be included)

KD450W_26_IB_E_130511_1.indd 9 13-03-11 3:43 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Shark KD450W Specifications Page 13

Comments to this Manuals

Related products and manuals for Vacuum cleaners Shark KD450W